Special Tools

Important: 

•	Do not allow the encoder to come into contact with external magnetic fields.

•	Do not allow the encoder to come into contact with metal swarf.

•	Do not damage the rubberized encoder track mechanically.

•	Do not drop the encoder.

1. Remove the encoder (1) from the crankshaft.
2. Disconnect the crankshaft pulse pick-up (2) from the pulse pick-up bracket.
3. Remove the bolt (1).
4. Remove the plastic ring on the pulse pick-up bracket (3).




Important: 

•	Only make a hole at the 5 o'clock and 7 o'clock positions (1), as these are the only areas where there is a cavity behind the seal ring.

•	The diameter of the hole must not exceed 2 mm. If the diameter of the hole exceeds 2 mm, the bolt of KM-6624 will not be able to grip.

5. Using a suitable tool, such as a scribe (2), make a hole in the seal ring.

Position the scribe at the outer edge of the seal ring.

Notice: Refer to Fastener Notice in the Preface section.

6. Remove the seal ring.

6.1.	Attach KM-6624 (1) to the seal ring.

Tighten
Tighten the bolt.

6.2.	Attach KM-328-B  (2) to KM-6624  (1).

6.3.	Using KM-328-B  (2) and KM-6624  (1), tap the seal ring out.