GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Saab 🢒 2009 🢒 9-7x 🢒 Body Repair 🢒 Bolted Exterior Body Panels and Closures 🢒 Upper Intake Manifold Sight Shield Replacement

Removal Procedure

    Object Number: 1725340 Size: SH
  1. Loosen intake manifold sight shield wing nut.
  2. Gently lift up in order to disengage the sight shield from the ball stud.
  3. Remove the sight shield from the sight shield retainer.

    4. Object Number: 1725341 Size: SH
  4. Remove the sight shield retainer bolts and the retainer, if required.
  5. Remove the sight shield ball stud, if required.

Installation Procedure

    Caution: Refer to Fastener Caution in the Preface section.


    Object Number: 1725341 Size: SH
  1. Install the sight shield ball stud, if required. Tighten the stud to 5 N·m (44 lb in).
  2. Position the sight shield retainer to the intake manifold and install the bolts, if required. Tighten the bolts to 3 N·m (26 lb in).

    3. Object Number: 1725340 Size: SH

    Caution: Use the connector test adapter kit J 35616-A for any test that requires probing the following items:

       • The PCM harness connectors
       • The electrical center fuse/relay cavities
       • The component terminals
       • The component harness connector
    Using this kit will prevent damage caused by the improper probing of connector terminals.

  3. Install the sight shield to the sight shield retainer.
  4. Seat the sight shield onto the ball stud and press down over the stud in order to secure the sight shield.
  5. Tighten intake manifold sight shield wing nut until snug.