Removal Procedure
Warning: Refer to Battery Disconnect Warning in the Preface section.
- Disconnect the negative battery cable.
- Disconnect the input shaft speed (ISS) sensor electrical connector.
- Remove the ISS sensor retaining bolt.
- Remove the ISS sensor from the transaxle.
Installation Procedure
Note: Lubricate the O-ring with ISU DEXRON III.
- Install a new O-ring on the ISS sensor.
Caution: Refer to Fastener Caution in the Preface section.
- Install the ISS sensor.
- Install the ISS sensor bolt and tighten to
5 N·m (44 lb in).
- Connect the ISS sensor electrical connector.
- Connect the negative battery cable.