Tools Required

Important: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and the interior trim.

1. Open the door.
2. Remove the windshield inside garnish moldings (1) from the vehicle. Refer to Windshield Pillar Garnish Molding Replacement .
3. Remove the rearview mirror. Refer to Inside Rearview Mirror Replacement .

Caution: If broken glass falls into the defroster outlets, it can be blown into the passenger compartment and cause personal injury.

4. Cover to protect the following parts from broken glass:

4.1.	Upper dash pad

4.2.	Defroster outlets and A/C outlets

4.3.	Seats and carpeting

5. Open the hood.
6. Remove the air inlet grille. Refer to Air Inlet Grille Panel Replacement .
7. Remove the windshield wiper arms. Refer to Windshield Wiper Arm Replacement .

Caution: If a window is cracked but still intact, crisscross the window with masking tape in order to reduce the risk of damage or personal injury.

Caution: When working with any type of glass or sheet metal with exposed or rough edges, wear approved safety glasses and gloves in order to reduce the chance of personal injury.





Important: The windshield reveal molding fills the cavities between the body and the windshield.

8. If the windshield reveal molding is stretched or damaged, replace the molding.



9. Remove the windshield reveal molding (1). Grasp the lower corner of the windshield reveal molding by hand and slowly pull the reveal molding away from the windshield.
10. If the windshield reveal molding will not release, use a utility knife in order to cut around the windshield in order to remove the windshield reveal molding.




Important: Keep the cutting edge of the tool against the window.

11. This will allow the urethane adhesive to be separated from the window.

•	Leave a base of urethane on the pinchweld flange.

•	The only suitable lubrication is clear water.

•	Use the J 24402-A , J 39032 , or equivalent in order to remove the window.




12. Remove the bottom of the window from the urethane adhesive using a long utility knife or similar tool.



13. Remove the windshield (1) from the vehicle with the aid of an assistant (2).

1. Replace the upper windshield stoppers (1) and (2).
2. Install a stationary window into the opening. Refer to Adhesive Installation of Stationary Windows .



3. Install the air inlet grille. Refer to Air Inlet Grille Panel Replacement .
4. Install the windshield wiper arms. Refer to Windshield Wiper Arm Replacement .
5. Close the hood.
6. Install the rearview mirror. Refer to Inside Rearview Mirror Replacement .
7. Install the windshield side garnish moldings (1). Refer to Windshield Pillar Garnish Molding Replacement .
8. Remove the double layer of masking tape from around the perimeter of the painted surfaces and the interior trim.
9. Close the door.