For 1990-2009 cars only
Removal Procedure
- Unclip and remove the inner mirror garnish (6) from the door.
- Remove the front side door trim. Refer to Front Side Door Trim Panel Replacement .
- Disconnect the front upper speaker electrical connector (5), if equipped.
- Disconnect the outside rearview mirror electrical connector (2).
- Remove the following components from the door:
| • | The 3 nuts |
| • | The front upper speaker (3), if equipped. |
| • | The outside rearview mirror (1) |
Installation Procedure
- Install the outside rearview mirror (1) to the door and the front upper speaker (3), if equipped. Secure the mirror with the 3 nuts.
- Connect the front upper speaker electrical connector (5), if equipped.
- Connect the outside rearview mirror electrical connector (2).
- Install the inner mirror garnish (6) to the door.
- Install the front side door trim panel. Refer to Front Side Door Trim Panel Replacement .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the outside rearview mirror nuts to 8 N·m (6 lb ft).
