Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Interior Lights Schematics | |||
1 | Did you review the Lighting System Description and Operation and perform the necessary inspections? | Go to Step 2 | |
2 | Verify that the Courtesy lamps are inoperative. Does the system operate normally? | Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 |
3 | Using a test lamp, check the dome lamp cavity 2 to ground. Does the test lamp illuminate? | Go to Step 5 | Go to Step 4 |
4 | Using a test lamp, backprobe the junction block 1, C1 cavity 3 to ground. Does the test lamp illuminate? | Go to Step 8 | Go to Step 6 |
5 | Replace the dome lamp. Refer to Dome Lamp Replacement . Did you complete the replacement? | Go to Step 13 | -- |
6 | Connect a test lamp from cavity 1 of the dome lamp to ground. When the door is open does the dome lamp illuminate? | Go to Step 7 | Go to Step 9 |
7 | Repair the open in the dome lamp ground circuit between the dome lamp and the multifunction alarm module. Refer to Wiring Repairs . Did you find and correct the condition? | Go to Step 13 | Go to Step 10 |
8 | Repair the open in the dome lamp feed circuit between the dome lamp cavity 2 and the junction block 1, C1. Refer to Wiring Repairs . Did you complete the repair? | Go to Step 13 | -- |
9 | Replace the junction block 1. Did you complete the repair? | Go to Step 13 | -- |
10 | Using a fused jumper wire, connect the junction block 2 C4 cavity 7 to ground. Does the dome lamp illuminate? | Go to Step 11 | Go to Step 12 |
11 | Replace the multifunction alarm module. Refer to Multifunction Alarm Module Replacement . Is the replacement complete? | Go to Step 13 | -- |
12 | Repair the open in the dome lamp ground circuit and/or replace the door jamb switch, as needed. Refer to Wiring Repairs . Is the repair/replacement complete? | Go to Step 13 | -- |
13 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 3 |
