Schematic Reference: Instrument Cluster Schematics

Connector End View Reference: Component Connector End Views

Did you review the Power Door system Description and Operation?

Go to Step 2

Go to Power Door Locks Description and Operation

Disable the dome lamp override switch.

Is the dome lamp or the door ajar indicator always on?

Go to Dome Lamps Always On

Go to Step 3

Open each door individually while observing the dome lamps.

Does the dome lamp illuminate with each door?

Go to Step 4

Go to Dome Lamps Inoperative

1. Access the instrument panel cluster (IPC) connector.
2. With the doors closed, back probe the door ajar indicator control circuit with a test lamp that is connected to a good ground.

Does the test lamp illuminate?

Go to Step 5

Go to Step 6

Inspect for poor connections at the IPC connector. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .

Did you find and correct the condition?

Go to Step 10

Go to Step 9

Test for a short to ground in the door ajar indicator control circuit between the multifunction alarm module and the IPC. Refer to Circuit Testing and Wiring Repairs .

Did you find and correct the condition?

Go to Step 10

Go to Step 7

Inspect for poor connections at the multifunction alarm module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .

Did you find and correct the condition?

Go to Step 10

Go to Step 8

Replace the body control module (BCM). Refer to Control Module References .

Did you complete the replacement?

Go to Step 10

Replace the IPC. Refer to Instrument Cluster Replacement .

Did you complete the replacement?

Go to Step 10

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2