GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.

  2. Object Number: 2011016  Size: SH
  3. Using a flat-bladed tool, turn the pin (A) 90 degrees and remove the pin hold clip.

  4. Object Number: 2011018  Size: SH
  5. Remove the nine clips and the five screws.
  6. Remove the three grommets and the wheelhouse panel.

Installation Procedure

    Caution: Refer to Fastener Caution in the Preface section.


    Object Number: 2011018  Size: SH
  1. Install the wheel house panel  to the fender.
  2. Secure the wheel house panel with the five screws and the nine clips. Tighten the wheelhouse panel screws to 10 N·m (89 lb in).
  3. Install the three grommets.

  4. Object Number: 2014624  Size: SH
  5. Install the pin hold clip (1).
  6. Lower the vehicle.