The electronic brake control module (EBCM) turns ON the Antilock Brake System (ABS) indicator by opening the ABS indicator control circuit. The ABS indicator is connected to the GAUGE fuse. This circuit has power when the ignition switch is in the ON or START positions. When the ignition switch is turned to the ON position, the EBCM turns ON the ABS indicator for 3 seconds for a bulb check. If the EBCM detects a malfunction, the ABS indicator will stay ON to warn the driver that the ABS is disabled and needs service.

Schematic Reference

Antilock Brake System Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

ABS Description and Operation

Electrical Information Reference

Scan Tool Reference

Control Module References for scan tool information

1. Verify DTC U0073, U0123, U0124, or U0126 are not set.

⇒	If DTC U0073, U0123, U0124, or U0126 is set, refer to appropriate DTC.

1. Ignition OFF, disconnect the EBCM connector.
2. Ignition ON, check that ABS indicator illuminates.

⇒	If the ABS indicator illuminates, replace the EBCM/BPMV.

3. Using a scan tool, coomand the IPC display test ON and OFF. The ABS warning indicator should turn ON and OFF.

⇒	If IPC does not perform as specified, replace the IPC.

⇒	If IPC performs as specified, replace the BPMV/EBCM.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.