For 1990-2009 cars only
- Release the ratchet pawl, then fully push in the plunger and set the hook (1) to the pin (2) so that the plunger is in the position shown in the illustration.
- Install a new gasket and the chain tensioner with the 2 nuts and tighten to 9.0 N·m (80 lb in).
Note: Do not turn the crankshaft without the timing chain tensioner installed.
Caution: Refer to Fastener Caution in the Preface section.
Note: When installing the chain tensioner, set the hook again if the hook releases the plunger.
