Special Tools

EN-46104 Water Pump Pulley Holding Tool

1. Remove the four retaining bolts (2,3,4,5) from the water pump pulley using EN-46104.



2. Remove the clamp (1) of the crankshaft position sensor from the water pump.
3. Disconnect the wire of the crankshaft position sensor from the clamp bracket.



4. Remove the 4 bolts (1,2,3,5,6), 2 nuts (4,7) and clamp bracket.




Important: Tape the screwdriver tip before use.

5. Using a screwdriver, pry between the water pump and cylinder block, and then remove the water pump.