Special Tools

Note: Arrange the removed parts in the correct order.

1. Remove the valve stem caps from the cylinder heads.



2. Remove the intake valve.

Note: Arrange the removed parts in the correct order.

3. Using J-8062 compressor  (1) and EN-46353 adapter and wooden blocks (2), compress and remove the valve retainer locks.

Note: Arrange the removed parts in the correct order.

4. Remove the retainer, valve spring and intake valve.




Note: Arrange the removed parts in the correct order.

5. Using J-8062 compressor  (1) and wooden blocks (2), compress and remove the exhaust valve retainer locks.

Note: Arrange the removed parts in the correct order.

6. Remove the retainer, valve spring and exhaust valve.



7. Using EN-46116 remover/installer , remove the valve stem oil seals.



8. Using compressed air and a magnetic pick-up tool, remove the valve spring seats by blowing air onto them.




Note: If water leaks from any of the straight screw plugs or if the plug is corroded, replace it.

9. Using a 10 mm straight hexagon wrench, remove the 3 No. 2 STRAIGHT screw plugs and 3 gaskets.