GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2000 🢒 Trans Sport 🢒 Bulletins 🢒 Power Sliding Door Reverses on Closing (Replace Plunger and Contact Plate Using Kit, Replace Door Module and Latch, if Applicable)

Power Sliding Door Reverses on Closing (Replace Plunger and Contact Plate Using Kit, Replace Door Module and Latch, if Applicable)

Subject:Power Sliding Door Reverses on Closing (Replace Plunger and Contact Plate Using Kit; Replace Door Module and Latch, If Applicable)

Models:1997-1999 Chevrolet Venture
1997-2000 Oldsmobile Silhouette
1997-2000 Pontiac Trans Sport
1999-2000 Pontiac Montana

Attention: Make sure all prior recalls have been performed prior to the completion of this bulletin

Condition

Some customers may comment that the power sliding door (PSD) will reverse on closing or the door will appear closed, but the alarm will come on when the transmission is moved out of Park.

Cause

Corrupted detent switch signals may cause the above malfunctions. The PSD system relies on signals generated by the detent switch on the latch and transmitted through the plungers on the door side and pads on the body side to determine that the door is fully latched.

Correction

Important: For 1997 and 1998 Extended Wheelbase (5th VIN character "X") vehicles, follow Steps 1 through 3.

For 1998 Regular Wheelbase (5th VIN character "U"), and all 1999 and 2000 vehicles up to VINs 1GNDXO3E3YD100089,1GHDX03E9YD100147, and 1GMDX03E4YD100087, follow Steps 1 through 5.

  1. Replace the door side plunger and harness, which is supplied in the connector kit.

    2. Object Number: 849689 Size: SH
  2. Use the diagram and harness in the kit to upgrade the wire harness in the "B" pillar. This is an advantage to the PSD system electrical circuits in that the 1892 detent (latch ) signal and the 750 ground are doubled through the door to body contacts.
  3. Replace the flat contact plate on the "B" pillar which is supplied in the connector kit.

    4. Important: Both the controller and latch must be replaced. The new latch will not function with the previous versions of the controller.

  4. Replace the Power Sliding Side Door Controller. Refer to the Doors subsection of the Service Manual for module replacement (SI Document ID #508665).
  5. Replace the Power Sliding Side Door Latch. Refer to the Doors subsection of the Service Manual for latch replace. (SI Document ID #508709).
  6. Reinitialize the door after repair. Refer to the Doors subsection of the Service Manual for Power Sliding Door (PSD) Re-initialization (SI Document ID #601816).

Parts Information

Part Number

Description

10322517

Connector Kit

16640270

Module

16639314

Latch ASM

Parts are currently available from GMSPO.

Warranty Information

For vehicles repaired under warranty, use:

Labor Operation

Description

Labor Time

N8505

Harness, Wiring -- Repair, Replace or Install

Use Published Labor Operation Time

Add

For Items 1 through 3 (For Extended Wheel Base)

1.0 hr

Add

For items 1 through 6 (For Regular Wheel Base

1.8 hrs