Generator Front Brace Replacement 3100 Engine L82

1. Remove the bolt from the generator.
2. Remove the nut from the engine stud.
3. Remove the brace.

1. Position the brace to the generator and the engine stud.
2. Hand start the nut.
3. Install the bolt to the generator. Make sure that tightening bolts and screws does NOT bind the generator.

Tighten
Tighten the bolt to 50 N·m (37 lb ft).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Install the nut to the engine stud.

Tighten
Tighten the nut to 25 N·m (18 lb ft).