Removal Procedure
- Remove the rear seat cushion. Refer to
Rear Seat Cushion Replacement
in Seats.
- Remove the rear seat back. Refer to
Rear Split Folding Seat Back Replacement
in Seats.
- Remove the right carpet retainers. Refer to
Carpet Retainer Replacement
in Interior Trim.
- Remove the center pillar trim panel. Refer to
Center Pillar Upper Trim Panel Replacement
in Interior Trim.
- Pull back the carpet for access to the wiring harness as required.
- Disconnect the antenna coaxial cable from the rear of the radio. Refer
to
Radio Replacement
.
- Cut off the visible end of the coaxial antenna
cable (1) from the wiring harness in the instrument panel area.
- Pull down the rear compartment trim to access the coaxial cable at the
antenna base.
- Disconnect the coaxial cable from the antenna base.
- Cut off the visible end of the coaxial antenna cable from the wiring harness
in the rear shelf area.
Installation Procedure
- Install the coaxial antenna cables to the wiring harness. Use electrical tape
in order to secure the antenna extension cable to the top of the wiring harness. Secure
the cable to the harness at least every 150 mm (6 in).
- Connect the coaxial cable to the antenna base.
- Reposition the rear compartment trim to the desired appearance.
- Connect the coaxial antenna cable to the rear of the radio. Install the
radio. Refer to
Radio Replacement
.
- Reposition the carpet.
- Install the center pillar trim panel. Refer to
Center Pillar Upper Trim Panel Replacement
in Interior Trim.
- Install the right carpet retainers. Refer to
Carpet Retainer Replacement
in Interior Trim.
- Position the coaxial antenna cable from the body wiring harness to the
rear shelf area.
- Install the rear seat back. Refer to
Rear Split Folding Seat Back Replacement
in Seats.
- Install the rear seat cushion. Refer to
Rear Seat Cushion Replacement
in Seats.