Caution: Refer to Fastener Caution in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications.

Preliminary Procedure

Remove the wiper blade from the wiper arm. Refer to Windshield Wiper Blade Replacement.

Tip
Carefully lower the bare wiper arm onto the windshield.

1

Windshield Washer Arm Nut Cap

Tip
Use a small flat-bladed tool to remove the cap.

2

Windshield Washer Arm Nut

Tip
Hold the wiper arm blade into position on the windshield blackout voids when applying torque to the nut.

Tighten
32 N·m (24 lb ft)

3

Windshield Washer Nozzle Hose Assembly

Tip
Carefully remove the washer hose from the spray nozzle in the air inlet panel prior to removing the wiper arm.

4

Windshield Washer Arm Assembly

Tip

1. A slight up and down motion applied near the hinge point on the wiper arm will release the arm from the wiper pivot shaft.
2. Use a soft wire brush to clean the knurls on the pivot shaft prior to re-installing the wiper arm.

5

Blackout Voids

Tip
Position the edge of the wiper blade element to the top edges of the voids in the windshield blackout area.