Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides and overview of each diagnostic category. |
DTC Descriptors
DTC 1052: PPS Preload Failure Region 1DTC 1053: PPS Preload Failure Region 2
DTC 1054: PPS Preload Failure Region 3
DTC 1055: PPS Preload Failure Region 4
Circuit/System Description
The passenger presence system (PPS) is divided up into 4 regions. When there is an unwanted force being applied to one or more PPS regions, the PPS will set a diagnostic trouble code (DTC). If the PPS detects any preload DTC within the PPS, it will communicate to the sensing and diagnostic module (SDM) through a non GMLAN communications circuit that a PPS fault is present. The SDM will set DTC B0081 indicating a problem within the PPS and will suppress the deployment of the instrument panel (I/P) module and turn the AIR BAG indicator ON.
Conditions for Running the DTC
Ignition voltage is between 9-16 volts.
Conditions for Setting the DTC
The PPS will set a DTC when a region has detected a preload/pressure on it, refer to chart below for specific region.
DTC | Preload Regions |
|---|---|
DTC 1052 | Region 1 |
DTC 1053 | Region 2 |
DTC 1054 | Region 3 |
DTC 1055 | Region 4 |
Action Taken When the DTC Sets
| • | The PPS will set a DTC for the appropriate region and communicate the fault to the SDM. |
| • | The SDM will set DTC B0081 and commands the AIR BAG indicator ON. |
| • | The PPS will illuminate the passenger air bag status OFF indicator. |
Conditions for Clearing the DTC
| • | The PPS no longer senses the condition, and DTCs are cleared. |
| • | A history DTC will clear once 255 malfunction-free ignition cycles have occurred. |
Diagnostic Aids
| • | When passenger seat bottom trim cover is serviced or removed, the trim cover, when reinstalled may apply certain unwanted pressure to the PPS causing DTCs 1052-1055 to set. |
| • | It may be necessary to perform the PPS preload test procedure more then once before condemning the system. |
Reference Information
Schematic Reference
Connector End View Reference
Description and Operation
SIR System Description and Operation
Electrical Information Reference
| • | Circuit Testing |
| • | Wiring Repairs |
Scan Tool Reference
Circuit/System Testing
Important: When removing connectors inspect for damage or corrosion. Damage or corrosion in the following requires repair or replacement of the affected.
| • | PPS module |
| • | PPS module wiring harness |
- Verify DTC 1051 is not set.
- Verify that DTC 1052, 1053, 1054, or 1055 is not set.
| ⇒ | If DTC 1051 is set as current, refer to DTC 1051 . |
| ⇒ | If DTC is set perform Passenger Presence System Preload Test . If DTC resets, replace the PPS. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
| • | Control Module References for PPS module replacement, setup, and programming |
