For 1990-2009 cars only
Removal Procedure
- Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
- Disconnect the brake booster vacuum hose from the intake manifold.
- Disconnect the manifold absolute pressure (MAP) sensor electrical connector (1).
- Disconnect the ignition coil electrical connector (2).
- Disconnect the left side spark plug wires from the ignition coil.
- Disconnect the right side spark plug wires from the ignition coil.
- Remove the upper left coil mount bracket bolt (1).
- Raise the vehicle. refer to Lifting and Jacking the Vehicle .
- Disconnect the wire retainers on the ignition coil bracket.
- Remove the remaining bolt (1) and the two nuts (2) on the coil bracket.
- Lower the vehicle.
- Remove the ignition coil bracket assembly.
Installation Procedure
- Install the ignition coil (3).
- Raise the vehicle.
- Install the upper right coil mount bolt.
- Install the coil mount nuts and tighten to 25 N·m (15 lb ft) .
- Connect the wire retainers to the coil bracket.
- Lower the vehicle.
- Install the upper left coil mount bolt and tighten to 25 N·m (15 lb ft) .
- Connect the right side spark plug wires to the ignition coil.
- Connect the left side spark plug wires to the ignition coil.
- Connect the ignition coil electrical connector (2).
- Connect the MAP sensor electrical connector (1).
- Connect the brake booster vacuum hose to the intake manifold.
- Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
Caution: Refer to Fastener Caution in the Preface section.
