GM Service Manual Online
For 1990-2009 cars only
Makes
🢒
Pontiac
🢒
2009
🢒
Montana SV6
🢒
Diagnostic Navigation
🢒
Vehicle Diagnostic Information
🢒 Accelerator Pedal Position Sensor Replacement
Removal Procedure
Remove the insulator panel. Refer to
Knee Bolster Replacement
.
Remove the connector position assurance (CPA) retainer.
Disconnect the instrument panel (I/P) harness electrical connector (1) from the accelerator pedal.
Remove the accelerator pedal bolts.
Remove the accelerator pedal (2).
Installation Procedure
Install the accelerator pedal (2).
Caution:
Refer to
Fastener Caution
in the Preface section.
Install the accelerator pedal bolts (1) and tighten to
10 N·m (89 lb in)
.
Connect the I/P harness electrical connector (1) to the accelerator pedal.
Install the CPA retainer.
Install the insulator panel. Refer to
Knee Bolster Replacement
.
Verify the operation of the accelerator pedal.