Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you perform the Wiper/Washer System Check? | -- | Go to Step 2 | |
2 |
Do the wipers park? | -- | Go to Step 3 | Go to Step 4 |
3 | Replace the wiper/washer switch. Refer to Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle . Did you complete the replacement? | -- | Go to Step 9 | -- |
4 | Measure the voltage from connector C201 (vehicle side), terminal E2, to ground with a DMM. Does the voltage measure greater than the specified value? | 1.0 V | Go to Step 6 | Go to Step 5 |
5 | Replace the wiper motor cover. Refer to Wiper Motor Cover Replacement . Did you complete the replacement? | -- | Go to Step 9 | -- |
6 |
Does the voltage measure greater than the specified value? | 1.0 V | Go to Step 8 | Go to Step 7 |
7 | Replace the wiper motor cover. Refer to Wiper Motor Cover Replacement . Did you complete the replacement? | -- | Go to Step 9 | -- |
8 | Repair the short to voltage in CKT 113. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? | -- | Go to Step 9 | -- |
9 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK |
