Removal Procedure
Warning: Refer to Battery Disconnect Warning in the Preface section.
- Disconnect the negative battery cable.
- Remove the air filter, resonator with snorkel assembly. Refer to
Air Cleaner Assembly Replacement.
- Disconnect the optical sensor connector (1).
- Disconnect the ignition wires (2).
- Remove the ignition wire clip (3).
Note: Mark on the distributor housing and case before removing the distributor (1).
- Remove the distributor bolts (2).
- Carefully remove the distributor assembly (3).
Installation Procedure
Caution: Refer to Fastener Caution in the Preface section.
- Install the distributor bolts (1) and tighten to
10-16 N·m (89-142 lb in).
- Install the ignition wire clip.
- Connect the ignition wires and optical sensor connector.
- Install the air filter resonator with the snorkel assembly. Refer to
Air Cleaner Assembly Replacement.
- Connect the negative battery cable.