Removal Procedure
Caution: Refer to Battery Disconnect Caution in the Preface section.
- Disconnect the negative battery cable.
Caution: To avoid any vehicle damage, serious personal injury or death when major components are removed from the vehicle and the vehicle is supported by a
hoist, support the vehicle with jack stands at the opposite end from which the components are being removed and strap the vehicle to the hoist.
- Raise and suitably support the vehicle. Refer to
Lifting and Jacking the Vehicle
in General Information.
- Remove the front wheels. Refer to
Tire and Wheel Removal and Installation
in Tires and Wheels.
- Remove the front wheel house splash shield clip and bolts (2).
- Remove the wheel house splash shield (1).
- Remove
the theft deterrent alarm screws (1).
- Disconnect the electrical connector (2).
- Remove the theft deterrent alarm.
Installation Procedure
Notice: Refer to Fastener Notice in the Preface section.
- Install the theft deterrent alarm with the screws.
Tighten
Tighten the screws to 8 N·m (71 lb in)
- Connect the electrical connector.
- Install the front wheel house splash shield with the clips and the bolts.
- Install the front wheels. Refer to
Tire and Wheel Removal and Installation
in Tires and Wheels.
- Lower the vehicle.
- Connect the negative battery cable.