Parking and Turn Signal Lamp Bulb Replacement GT

The front park/turn lamp bulb shares the same housing as the fog lamp.

1. Remove the front fog lamp screws (1) from the fog lamp.



2. Remove the fog lamp from the front bumper fascia.
3. Remove the park/turn lamp bulb/socket from the fog lamp, turning counterclockwise, if required.



4. Disconnect the electrical connector from the park/turn lamp bulb/socket.

1. Connect the electrical connector to the park/turn lamp bulb/socket.



2. Install the park/turn lamp bulb/socket to the fog lamp, turning clockwise, if required.
3. Position the fog lamp to the front bumper fascia.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Install the front fog lamp screws (1) to the fog lamp.

Tighten
Tighten the screws to 2 N·m (18 lb in).

5. Inspect and adjust the front fog lamp aim as necessary. Refer to Fog Lamp Aiming .

Parking and Turn Signal Lamp Bulb Replacement GXP