GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2005 🢒 Grand Prix 🢒 Body 🢒 Wiring Systems 🢒 Inflatable Restraint Roof Side Rail Module Replacement - Right Side

Removal Procedure

    Caution: Refer to SIR Caution in the Preface section.

    Caution: Refer to SIR Inflator Module Handling and Storage Caution in the Preface section.

    Caution: In order to prevent SIR deployment, personal injury, or unnecessary SIR system repairs, do not strike the door or the door pillar in the area of the side impact sensor (SIS). Turn OFF the ignition and remove the key when performing service in the area of the SIS.

  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Lower the headliner to access the inflator module. Refer to Headlining Trim Panel Replacement in Interior Trim.

    3. Object Number: 925211 Size: SH
  3. Release the connector positive assurance (CPA) (1) on the inflator harness connector (2).

    4. Object Number: 902186 Size: SH
  4. Disconnect the harness connector (2) from the inflator (3).
  5. Remove the headliner electrical harness push-in connector from the inflator bracket.
  6. Remove the screws (1) from the roof rail module.

    7. Object Number: 902190 Size: SH
  7. Remove the push-in retainer (2) from the inflator bracket (1).
  8. Remove the screw (3) from the inflator bracket.
  9. Remove the roof rail module from the vehicle.

Installation Procedure
  1. Remove any dirt, grease, or other impurities from the mounting surface. Inspect the nuts and replace if necessary.

    2. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 902190 Size: SH

    Caution: Apply Loctite 242® Threadlocker US P/N 12345382 (Canadian P/N 10953489), or equivalent, on all restraint bolts/nuts before installation. Failure to use such threadlocker correctly may result in personal injury.

    Caution: Do not strike or jolt the inflatable restraint side impact sensor (SIS). Before applying power to the SIS make sure that it is securely fastened. Failure to observe the correct installation procedures could cause SIR deployment, personal injury, or unnecessary SIR system repairs.

  2. Install the inflator bracket screw (3).

    3. Tighten
    Tighten the screw to 10 N·m (89 lb in).

  3. Install the inflator bracket push-in retainer (2).

    4. Object Number: 902186 Size: SH

    Important: Make certain the roof rail module is not twisted when installed.

  4. Position the roof rail module over the sail panel bracket (4).

    5. Important: The sunroof drainage hoses must be routed outboard of the roof rail module.

  5. Install the inflatable restraint roof rail module screws (1).

    6. Tighten
    Tighten the screws to 10 N·m (89 lb in).

  6. Install the harness connector (2) to the inflator (3). Engage the CPA.
  7. Install the headliner electrical harness retainer to the inflator bracket.
  8. Install the headliner. Refer to Headlining Trim Panel Replacement in Interior Trim.
  9. Enable the SIR system. Refer to SIR Disabling and Enabling .
  10. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping .