GM Service Manual Online
For 1990-2009 cars only

Tools Required

J 38778 Door Trim Pad and Garnish Clip Remover

Removal Procedure

  1. Open the rear compartment lid.

  2. Object Number: 876803  Size: SH
  3. Use J 38778 to remove the push-in retainers from the trim panel on the rear compartment lid.
  4. Unscrew the two cargo tie down retainers.
  5. Remove the trim panel from the rear compartment lid.

Installation Procedure


    Object Number: 876803  Size: SH
  1. Position the trim panel to the rear compartment lid.
  2. Install the push-in retainers to the trim panel.
  3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the two cargo tie down retainers.
  5. Tighten
    Tighten the retainers to 4 N·m (35 lb in).

  6. Close the rear compartment lid.