GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2004 🢒 Grand Prix 🢒 Preface 🢒 Cautions and Notices 🢒 Instrument Cluster Head Up Display Replacement

Removal Procedure
  1. Pull the I/P accessory trim plate rearward slightly for access to the steering column filler. Refer to Instrument Panel Accessory Trim Plate Replacement .
  2. Remove the I/P steering column opening filler. Refer to Steering Column Opening Filler Replacement .
  3. Remove the I/P cluster trim plate. Refer to Instrument Cluster Trim Panel Replacement .
  4. Remove the instrument cluster. Refer to Instrument Cluster Replacement .
  5. Remove the windshield pillar garnish moldings. Refer to Windshield Pillar Garnish Molding Replacement in Interior Trim.

    6. Notice: Use the following method to disengage the Head Up Display (HUD) retainers. Do NOT pry the retainers with a flat-bladed tool or other similar device.

    1. Disengage the I/P upper trim panel retainers on the sides of the HUD.
    2. Disengage the retainer rearward of the HUD.
    Failure to follow this method could break the tab on the HUD.

  6. Remove the I/P upper trim panel. Refer to Instrument Panel Upper Trim Panel Replacement .

    7. Object Number: 1198005 Size: SH
  7. Remove the HUD screw.

    8. Object Number: 1198037 Size: SH
  8. Remove the HUD bolts.

    9. Object Number: 1200054 Size: SH
  9. Adjust the HUD for access. Disconnect the HUD electrical connector.
  10. Remove the HUD

Installation Procedure

    Object Number: 1200054 Size: SH
  1. Connect the HUD electrical connector. Lower the HUD into the I/P opening.

    2. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1198037 Size: SH
  2. Start the HUD bolts by hand to avoid cross threading. Install the HUD bolts.

    3. Tighten
    Tighten the bolts to 10 N·m (89 lb in).


    Object Number: 1198005 Size: SH
  3. Install the HUD screw.

    4. Tighten
    Tighten the screw to 2 N·m (18 lb in).

  4. If a new HUD was installed remove the protective plastic sheet from the glass.
  5. Install the I/P upper trim panel. Refer to Instrument Panel Upper Trim Panel Replacement .
  6. Install the windshield pillar garnish moldings. Refer to Windshield Pillar Garnish Molding Replacement in Interior Trim.
  7. Install the instrument cluster. Refer to Instrument Cluster Replacement .
  8. Install the I/P cluster trim plate. Refer to Instrument Cluster Trim Panel Replacement .
  9. Install the I/P steering column opening filler. Refer to Steering Column Opening Filler Replacement .
  10. Install the I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement .