Steering Angle Sensor Centering Procedure
The steering angle sensor does not require centering often. Centering
of the steering angle sensor might be required after certain service procedures
are performed. Some of these procedures are as follows:
| • | Steering gear replacement |
| • | Steering column replacement |
| • | Steering angle sensor replacement |
| • | Intermediate shaft replacement |
| • | ABS controller replacement |
| • | Collision or other physical damage |
| • | Engine cradle replacement |
The steering angle sensor centering procedure can be preformed with
a scan tool in the automated center procedure by the following:
- Using the steering wheel, align the front wheels forward.
- Set the transmission in the park position.
- Install the scan tool to the DLC.
- Turn the ignition switch ON, with the engine OFF.
- Select ABS/TCS/VSES, special function out put test, and automated
centering procedure.
- Follow the scan tool directions to complete the automated centering
procedure.
- Clear any DTCs that may be set, perform the Diagnostic System
Check to verify no current DTCs. Refer to
Diagnostic System Check - ABS
.
- Centering of the steering angle sensor is complete.
