Connector End View Reference: Cooling System Connector End Views

Did you perform the Engine Cooling Diagnostic System Check?

Go to Step 2

Go to Diagnostic System Check - Engine Cooling

Start the engine.

Does the hot coolant indicator illuminate?

Go to Step 3

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

1. Install a scan tool.
2. With a scan tool, observe the engine coolant temperature (ECT) sensor parameter in the Powertrain Control Module data list.

Does the scan tool indicate that the coolant temperature is within the temperature range shown on the temperature gauge?

Go to Engine Overheating

Go to Step 4

Replace the IPC. Refer to Instrument Cluster Replacement in Instrument Panel, Gages, and Console.

Did you complete the repair?

Go to Step 5

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2