For 1990-2009 cars only
Removal Procedure
- Drain the cooling system. Refer to Cooling System Draining and Filling .
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Disconnect the coolant heater cord from the coolant heater.
- Loosen the bolt at the coolant heater but DO NOT remove the coolant heater bolt.
- Remove the coolant heater.
- Remove and clean any burrs, compound, paint, or rough spots from the core plug hole.
Installation Procedure
- Apply GM P/N 12346004 (Canadian P/N 10953480) or equivalent to the following:
- Install the coolant heater by pushing tight to the block.
- Position the engine coolant heater element at the 9 o'clock position (2).
- Tighten the coolant heater bolt until both locking wings draw tight against the inner wall of the engine block.
- Connect the engine coolant heater cord to the engine coolant heater.
- Fill the cooling system. Refer to Cooling System Draining and Filling .
| • | Engine block heater seal |
| • | Cleaned surface of the engine block heater hole |
Final installed position between 10 o'clock (1) and 8 o'clock (3) is acceptable.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolt to 2 N·m (17 lb in).
