For 1990-2009 cars only
Removal Procedure
- Remove the overhead console lamp bezel by using a small flat-bladed tool to release the 2 rear retaining tabs.
- Lower the rear edge of the bezel, releasing the forward locating tab.
- Disconnect the electrical connector from the overhead console lamp.
- Remove the lamp housing screws.
- Remove the bezel and the lens from the overhead console lamp housing.
- Remove the bulb(s) from the socket(s) using a small flat-bladed tool.
Installation Procedure
- Install the bulb(s) to the overhead console lamp socket(s).
- Position the lamp lens and the bezel to the overhead console lamp housing.
- Install the overhead console lamp housing screws.
- Connect the electrical connector to the overhead console lamp.
- Position the forward locating tab of the overhead console lamp bezel to the overhead console.
- Position the 2 rear retaining tabs to the overhead console.
- Install the overhead console lamp bezel pressing the bezel into place until fully seated.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the screws to 11 N·m (97 lb in).
