Removal Procedure
- Insert a small, plastic
flat-bladed tool into the slot on the rear edge of the sensor bezel and release
the bezel retainer from the instrument panel upper trim panel.
- Remove the sensor bezel from the upper trim plate.
- Remove the daytime running
lamp (DRL) ambient light sensor by turning counterclockwise to release the
sensor from the sensor bezel.
- Disconnect the electrical connector from the DRL ambient light
sensor.
Installation Procedure
- Connect the electrical
connector to the DRL ambient light sensor.
- Install the DRL ambient light sensor to the sensor bezel, then
rotate the sensor clockwise to secure.
- Position the forward edge
of the sensor bezel to the instrument panel upper trim panel.
- Press the rear edge of the sensor bezel down until the rear retainers
are seated correctly.