GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2001 🢒 Grand Prix 🢒 HVAC 🢒 HVAC Systems - Manual 🢒 Temperature Valve Actuator Replacement

Removal Procedure
  1. Remove the knee bolster. Refer to Knee Bolster Replacement in Instrument Panel, Gauges and Console.

    2. Object Number: 295297 Size: SH
  2. Disconnect the electrical connector from the air temperature actuator.
  3. Remove the mounting screws from the air temperature actuator.

    4. Object Number: 295301 Size: SH
  4. Remove the air temperature actuator.

Installation Procedure

    Object Number: 295301 Size: SH
  1. Position the air temperature actuator, then align the slots in the electric actuator driver to the flats on the shaft.
  2. Align the locating hole to the alignment pin on the HVAC module case.
  3. Slide the actuator driver on the shaft. The actuator driver should set completely on the shaft and he mounting holes should be flush with the mounting screws on the HVAC module case.

    4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the mounting screws to the air temperature actuator.

    5. Tighten
    Tighten the air temperature actuator screw to 1.5 N·m (13 lb in).


    Object Number: 295297 Size: SH
  5. Connect the electrical connector to the air temperature actuator.
  6. Install the knee bolster. Refer to Knee Bolster Replacement in Instrument Panel, Gauges and Console.