GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical-3.8L.

  2. Object Number: 12287  Size: SH
  3. Remove the left instrument panel sound insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gages and Console.
  4. Remove the accelerator cable (5) from the accelerator pedal (1).

  5. Object Number: 12262  Size: SH
  6. Squeeze the accelerator cable cover tangs.
  7. Push the accelerator cable through the bulkhead.

  8. Object Number: 12717  Size: SH
  9. Remove the accelerator cable from the retaining clip.

  10. Object Number: 12265  Size: SH
  11. Remove the accelerator cable from the throttle body lever.

  12. Object Number: 12258  Size: SH
  13. Remove the accelerator cable from the accelerator controls cable bracket.

  14. Object Number: 12715  Size: SH
  15. Remove the accelerator cable from the vehicle and verify routing for installation.

Installation Procedure

Notice: Do not route flexible components (hoses, wires, conduits, etc.) within 50 mm (2 in) of moving parts unless flexible components can be securely fastened. This is necessary in order to prevent possible interference and damage to the component.

Important: The throttle should operate freely, without binding, between full closed and wide open throttle.


    Object Number: 12715  Size: SH
  1. Install accelerator cable into vehicle using routing verified during removal.

  2. Object Number: 12262  Size: SH
  3. Slide the accelerator cable through the bulkhead.
  4. Install the snap retainer into the bulkhead.

  5. Object Number: 12287  Size: SH
  6. Install the accelerator cable (5) to the accelerator pedal (1).
  7. Seat the snap retainer in the accelerator pedal lever.

  8. Object Number: 12265  Size: SH
  9. Install the accelerator cable to the throttle body lever.

  10. Object Number: 12258  Size: SH
  11. Install the accelerator cable to the accelerator cable bracket.

  12. Object Number: 12717  Size: SH
  13. Install the accelerator cable to the retaining clip.
  14. Inspect for complete throttle opening and closing positions by operating the accelerator pedal. Also inspect for poor carpet fit under the accelerator pedal.
  15. Install the left instrument panel sound insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gages and Console.
  16. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical-3.8L.