Was the Automatic Door Locks System Check performed?

--

Go to Step 2

Go to Automatic Door Locks System Check

1. Disconnect the inoperative door lock connector C2 (actuator motor).
2. Use a test light in order to connect between the inoperative door lock connector C2 terminals A and B.
3. Observe the test light and press either door lock switch to the UNLOCK position.

Does the test light illuminate while you press UNLOCK?

--

Go to Step 4

Go to Step 3

1. Use a test light in order to connect between the inoperative door lock connector C2 terminal A and ground.
2. Observe the test light and press either of the door lock switches to the UNLOCK position.

Does the test light illuminate when you press UNLOCK?

--

Go to Step 5

Go to Step 6

Replace the inoperative door lock (actuator motor) Refer to Front Side Door Lock Actuator Replacement or Rear Side Door Lock Actuator Replacement .

Is the repair complete?

--

System OK

--

Repair the poor connection or the open in circuit 295.

Is the repair complete?

--

System OK

--

Repair the poor connection or the open in the following circuits, as needed:

Is the repair complete?

--

System OK

--