GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2000 🢒 Grand Prix 🢒 Body and Accessories 🢒 Body Control System 🢒 Content Theft Deterrent (CTD) Operation

The Content Theft Deterrent (CTD) system (UA6) deters vehicle vandalism and theft by performing the following functions:

    • Flashing the headlamps
    • Activating the horn intermittently
    • Disabling the vehicle's fuel system

These actions occur when the following conditions exist:

    • The theft deterrent system is armed.
    • A vehicle tamper condition has occurred.

Arming

Complete the following steps in order to arm the content theft deterrent system:

  1. Turn the ignition switch to the OFF position.
  2. Remove the key from the ignition lock cylinder.
  3. Open the driver's door.
  4. Press the lock on either power door lock switch or the keyless entry transmitter.

The security indicator lamp flashes while the driver door is open during the arming cycle. The lamp lights steadily when the following conditions exist:

    • The driver side door is closed.
    • The content theft deterrent system enters the arming mode.

The security LED flashes continuously at a slow rate when the content theft deterrent system is armed.

Disarming

Use either of the following steps in order to disarm the content theft deterrent system:

    • Unlock either door by using the key in the key lock cylinder.
    • Press UNLOCK on a keyless entry transmitter.

Alarm

The content theft deterrent system activates the alarm when the system is armed and one of the following events occurs:

    • A door is opened.
    • The ignition switch is turned to one of the following positions:
       - ACC
       - RUN
       - CRANK
    • The rear compartment lock cylinder is removed from the rear compartment lid.
    • The vehicle is impacted in excess of the precalibrated level of the shock sensor.

       Important: The following actions occur when the transmitter ALARM button is pressed:
   • The interior lamps light.
   • The horn sounds intermittently.
   • The headlamps flash for 2 minutes.
These actions will end when one of the following actions occurs:
   • The ALARM button is pressed again.
   • The ignition key is turned to the RUN or the ON position.

    • The ALARM button is pressed on the keyless entry transmitter.

The content theft deterrent system causes the following signals for 2 minutes during alarm mode:

    • The headlamps flash.
    • The horn is sounded.

Warning

The content theft deterrent system causes the following actions when the shock sensor detects an impact to the vehicle that may be caused by tampering:

    • 5 seconds of headlamp flashing
    • Intermittent horn activation

Operating Modes

The content theft deterrent system has the following operating modes:

    • The stand-by mode
    • The lamp flashing mode
    • The lamp steady on mode
    • The ignition on mode
    • The delay mode
    • The armed mode
    • The re-arm wait mode
    • The warning mode
    • The alarm mode
    • The trunk wait mode
    • The trunk open mode
    • The trunk delay mode

Stand-By Mode

The security LED is off during the stand-by mode.

The content theft deterrent system enters the stand-by mode when all of the following conditions exist:

    • The doors are unlocked in one of the following ways:
       - UNLOCK is pressed on the keyless entry transmitter.
       - The door key cylinders are used when the arm/disarm is in mode 1.
    • The ignition switch is in the OFF or UNLOCK position with the key fully inserted in the ignition key lock cylinder.
    • All of the vehicle doors are closed.

Turning the ignition switch to the ACC or the RUN position causes the content theft deterrent system to exit the stand-by mode and enter into the ignition on mode.

Lamp Flashing Mode

In the lamp flashing mode, the security LED flashes for 10 minutes and then turns off. In vehicles with less than 15 total accumulated miles, the security LED flashes for 3 minutes.

The content theft deterrent system enters the lamp flashing mode when all of the following conditions exist:

    • The key is removed from the ignition key lock cylinder.
    • Any door is open.
    • The doors are unlocked in one of the following ways:
       - UNLOCK is pressed on the keyless entry transmitter.
       - The door key cylinders are used when the arm/disarm is in mode 1.

The content theft deterrent system exits the lamp flashing mode and goes into the ignition on mode when the ignition switch is turned to the ACC or the RUN position.

Lamp On Steady Mode

In the lamp on steady mode, the security LED is on for 10 minutes and then turns off. In vehicles with less than 15 total accumulated miles, the security LED turns on for 3 minutes.

The content theft deterrent system enters the lamp on steady mode when all of the following conditions exist:

    • The ignition switch is removed from the ignition key lock cylinder.
    • Any door is open.
    • LOCK is pressed on the keyless entry transmitter or the power door lock switch.

The content theft deterrent system exits the lamp on steady mode and goes into the ignition on mode when the ignition switch is turned to the ACC or RUN position.

Ignition On Mode

In the ignition on mode, the lamp is in the OFF position.

Turning the ignition switch to the ACC or RUN position during one of the following modes will cause the theft deterrent system to enter into the ignition mode:

    • Stand-by
    • Lamp flashing
    • Lamp on steady
    • Delayed

The content theft deterrent system stays in the ignition on mode when the ignition switch is in the ACC or RUN position.

Delay Mode

In the delay mode, the security LED is on.

The content theft deterrent system enters the delay mode when all of the following conditions exist:

    • The key is removed from the ignition key lock cylinder.
    • All of the doors are closed.
    • The rear compartment lid is closed.
    • LOCK is pressed on the keyless entry transmitter or a power door lock switch.

The BCM remains in delay mode for 1 second and then goes into armed mode. If the rear compartment lid is open, the BCM goes into the trunk open mode.

The content theft deterrent system exits the delay mode and goes into the ignition on mode when the ignition switch is turned to the ACC or RUN position.

Armed Mode

In the armed mode, the security LED flashes slowly.

When the content theft deterrent system enters the armed mode, the BCM performs the following functions:

    • For remote activation verification in mode 3 or mode 4, the BCM sounds the horn for 23-27 ms.
    • For remote activation verification in mode 2, mode 3 or mode 4, the BCM flashes the headlamps once after sounding the horn.

The content theft deterrent system stays in the armed mode until one of the following conditions exists:

    • LOCK is pressed on the keyless entry transmitter. The system goes into the stand-by mode.
    • The door is unlocked using the door key cylinder when the arm/disarm is in mode 1 or 3. The system goes into the stand-by mode.
    • A vehicle door is opened. The system goes into the alarm mode.
    • Tampering with the rear compartment lock occurs. The system goes into the warning mode.
    • The shock sensor is triggered when the arm/disarm is in mode 1 or 3. The system goes into the alarm mode.
    • The ignition switch is turned from the OFF position to the ACC or RUN position. The system goes into the alarm mode.
    • The rear compartment lid is opened. The system goes into the trunk open mode.

Re-Arm Wait Mode

In the re-arm wait mode, the security LED is on.

The BCM waits for all trigger inputs to clear before entering the re-arm wait mode after an alarm mode operation.

The content theft deterrent system stays in the re-arm wait mode for 2 seconds when all of the following conditions exist:

    • All of the vehicle doors remain closed.
    • No tampering occurs with the rear compartment lock.
    • The shock sensor is not triggered.
    • The ignition switch remains in the OFF position.

After 2 seconds, the content theft deterrent system goes into the armed mode. If the rear compartment lid is open, the content theft deterrent system goes into the trunk open mode.

Warning Mode

In the warning mode, the lamp is on.

The warning mode attempts to warn away potential intruders before the content theft deterrent system goes into the alarm mode. The BCM flashes the headlamps and sounds the horn alternately 5 times rapidly. Then the content theft deterrent system goes into the armed mode.

The content theft deterrent system remains in the warning mode until one of the following actions occurs:

    • A vehicle door is opened. The system goes into the alarm mode.
    • The shock sensor is triggered when the arm/disarm is in mode 1 or 3. The system goes into the alarm mode.
    • The ignition switch is turned from the OFF position to the ACC or RUN position. The system goes into the alarm mode.
    • The rear compartment lid is opened. The system goes into the trunk open mode.
    • The content theft deterrent system has been in the warning mode 5 times. The system goes into the alarm mode.

Alarm Mode

In the alarm mode, the security LED is on.

The BCM flashes the headlamps and sounds the horn alternately for 2 minutes. The content theft deterrent system then enters the re-arm wait mode.

The content theft deterrent system stays in the alarm mode until one of the following actions occurs:

    • LOCK is pressed on the keyless entry transmitter. The system goes into the stand-by mode.
    • The door is unlocked using the door key cylinder when the arm/disarm is in mode 1 or 3. The system goes into the stand-by mode.
    • ALARM is pressed on the keyless entry transmitter. The system goes into the re-arm wait mode.

Trunk Wait Mode

In the trunk wait mode, the security LED flashes.

The content theft deterrent system enters the trunk wait mode the REAR COMPARTMENT button on the keyless entry transmitter is pressed. The BCM monitors the trunk open input in order to receive a signal indicating that the rear compartment lid is open.

The content theft deterrent system stays in the trunk wait mode until one of the following actions occurs:

    • The rear compartment lid is opened. The system goes into the trunk open mode.
    • UNLOCK is pressed on the keyless entry transmitter. The system goes into the stand-by mode.
    • The door is unlocked using the door key cylinder when the arm/disarm is in mode 1 or 3. The system goes into the stand-by mode.
    • A vehicle door is opened. The system goes into the alarm mode.
    • The shock sensor is triggered when the arm/disarm is in mode 1 or 3. The system goes into the alarm mode.
    • The ignition switch is turned from the OFF position to the ACC or RUN position. The system goes into the alarm mode.

Trunk Open Mode

In the trunk open mode, the security LED flashes.

The BCM enters the re-arm wait mode when the rear compartment closes. When the content theft deterrent system is in the trunk open mode, the BCM ignores inputs from the shock sensor and the rear compartment lid tamper switch.

The BCM causes the following actions when the system enters the trunk open mode:

    • For remote activation verification in mode 3 or mode 4, the BCM sounds the horn once.
    • For remote activation verification in mode 2, mode 3 or mode 4, the BCM flashes the headlamps once.

The content theft deterrent system stays in the trunk open mode until one of the following actions occurs:

    • The rear compartment lid is closed. The system goes into the trunk delay mode.
    • UNLOCK is pressed on the keyless entry transmitter. The system goes into the stand-by mode.
    • The door is unlocked using the door key cylinder when the arm/disarm is in mode 1 or 3. The system goes into the stand-by mode.
    • A vehicle door is opened. The system goes into the alarm mode.
    • Turning the ignition switch from the OFF position to the ACC or RUN position causes the system to go into the alarm mode.

Trunk Delay Mode

In the trunk delay mode, the security LED flashes.

After the rear compartment is closed, the content theft deterrent system waits 2 seconds before going into the re-arm wait mode. When the content theft deterrent system is in the trunk delay mode, the BCM ignores the shock sensor. Any residual shock sensor signals end during the 2 second time period.

The content theft deterrent system stays in the trunk delay mode for 2 seconds, or until one of the following actions occurs:

    • UNLOCK is pressed on the keyless entry transmitter. The system goes into the stand-by mode.
    • The door is unlocked using the door key cylinder when the arm/disarm is in mode 1 or 3. The system goes into the stand-by mode.
    • A vehicle door is opened. The system goes into the alarm mode.
    • The ignition switch is turned from the OFF position to the ACC or RUN position. The system goes into the alarm mode.
    • The rear compartment lid is opened. The system goes into the trunk open mode.

After 2 seconds in the trunk delay mode, the content theft deterrent system goes into the re-arm wait mode.