GM Service Manual Online
For 1990-2009 cars only

Step

Action

Value(s)

Yes

No

DEFINITION: The courtesy lights do not turn on when any door is open.

1

Was the Interior Lamps System Check performed?

--

Go to Step 2

Go to Interior Lamps System Check

2

Was the BCM Diagnostic System Check performed?

--

Go to Step 3

Go to Diagnostic System Check - Body Control System in Body Control System

3

  1. Close all of the vehicle doors.
  2. Enter the BCM Input/Output test. Refer to Body Control Module Diagnostic Information in Body Control System.
  3. Open, then close each door, one at a time. Listen to the chime.

Does the chime sound when opening each door?

--

Go to Step 4

Go to Step 5

4

    • Inspect the BCM connector for poor terminal contact. Perform repairs as needed.
    • If the terminal contact is OK, replace the BCM. Refer to Body Control Module Replacement in Body Control System.

Is the repair complete?

--

Go to Step 10

--

5

Is the door the driver's door?

--

Go to Step 6

Go to Step 7

6

  1. Open the driver's door.
  2. Using a test light, probe between B+ and BCM connector C2 terminal C1.

Does the test light illuminate?

--

Go to Step 4

Go to Step 9

7

  1. Open any passenger door. Do not use the driver's door.
  2. Using a test light, backprobe between B+ and the BCM connector C2 terminal C3.

Does the test light illuminate?

--

Go to Step 4

Go to Step 8

8

Repair the poor connection or open in circuit 49.

Is the repair complete?

--

Go to Step 10

--

9

Repair the poor connection or open in circuit 159.

Is the repair complete?

--

Go to Step 10

--

10

  1. Turn the ignition switch to the OFF position.
  2. Reconnect the connectors and reinstall the components that were removed.
  3. Turn the ignition switch to the RUN position for 6 seconds.
  4. Turn the ignition switch to the OFF position.
  5. Remove the MALL fuse.
  6. Turn the ignition switch to the ACC position. (The BCM sounds the chime a number of times equivalent to the BCM type installed on the vehicle).
  7. Within 1 second, turn the ignition switch from the ACC position, to the OFF position, then back to the ACC position. (The BCM sounds any DTCs stored).

Are there any BCM DTCs present?

--

Go to Diagnostic System Check - Body Control System in Body Control System

Go to Interior Lamps System Check