GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. For the overhead console without storage compartment, perform the following steps.

  2. Object Number: 317100  Size: MH
  3. Insert a flat-bladed tool in the side opposite the windshield and unsnap the overhead console.
  4. Disconnect the electrical connectors.
  5. Remove the console from the car.
  6. For the overhead console with the storage compartments, perform the following steps.
  7. Insert a flat-bladed tool in the side opposite the windshield and unsnap the overhead console lamp.
  8. Disconnect the electric connector.
  9. Insert a flat-bladed tool in the storage compartments and unsnap the storage units.

  10. Object Number: 317109  Size: SH
  11. Remove the overhead console screws.
  12. Remove the overhead console housing.
  13. Remove the backing plate.

Installation Procedure

  1. For the overhead console without storage compartment, perform the following steps.
  2. Connect the electric connector.

  3. Object Number: 317100  Size: MH
  4. Press the console back into the roof.
  5. Make sure the retainers snap back to secure the unit.

  6. For the overhead console with the storage compartments, perform the following steps.

  7. Object Number: 317109  Size: SH
  8. Install the backing plate.
  9. Install the overhead console housing.
  10. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  11. Install the overhead console screws.
  12. Tighten
    Tighten the overhead console screws to 2 N·m (18 lb in).

  13. Press the storage units back into the console.
  14. Make sure the retainers snap back to secure the unit.

  15. Connect the electrical connectors.
  16. Install the overhead console reading lamp.