Assist Strap Replacement Front

1. Pull down on the assist handle in order to expose the retaining screws (1).



2. Remove the assist handle screws (1).
3. Remove the assist handle.

1. Position the assist handle in the vehicle.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the assist handle screws.

Tighten
Tighten the assist handle screws to 3 N·m (27 lb in).

Assist Strap Replacement Rear

Important: The assist handle retaining screws are located under the handle. Do not remove the roof rail lamp cover and remove its two screws. The retainers (1) for these screws will fall behind the headliner.

1. Rear Assist Handle: Pull the assist handle down to expose its screws.



2. Remove the two screws (2).
3. Disconnect the roof rail lamp electric connector.
4. Remove the assist handle from the vehicle.

1. Position the rear assist handle to the headliner.



2. Connect the roof rail lamp connector.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the assist handle screws.

Tighten
Tighten the assist handle screws to 3 N·m (27 lb in).