Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:

1. Remove the front bumper fascia upper support from the hood latch support. Refer to Front Bumper Fascia Upper Support Replacement .
2. Remove the hood latch from the hood latch support. Refer to Hood Primary and Secondary Latch Replacement .
3. Remove the bolts from the hood latch support at the upper tie bar.
4. Remove the nut from the hood latch support at the lower tie bar.

1. Position the hood latch support to the upper and lower tie bar.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the bolts to the hood latch support at the upper tie bar.

Tighten
Tighten the hood latch support bolts to 25 N·m (18 lb ft).

3. Install the nut to the hood latch support at the lower tie bar.

Tighten
Tighten the latch support nut to 10 N·m (89 lb in).

4. Install the hood latch to the hood latch support Refer to Front Bumper Fascia Upper Support Replacement .
5. Install the front bumper fascia upper support to the hood latch support. Refer to Front Bumper Fascia Upper Support Replacement .