For 1990-2009 cars only
Removal Procedure
- Remove the throttle body air inlet duct. Refer to Air Cleaner Assembly Replacement in Engine Controls.
- Remove the automatic transaxle range selector cable from the automatic transaxle range selector lever.
- Remove the automatic transaxle range selector cable from the bracket.
- Remove the automatic transaxle range selector cable bracket bolts.
- Remove the automatic transaxle range selector cable bracket.
Installation Procedure
- Install the automatic transaxle range selector cable bracket.
- Install the automatic transaxle range selector cable bracket bolts.
- Install the automatic transaxle range selector cable to the bracket.
- Install the automatic transaxle range selector cable to the automatic transaxle range selector lever.
- Adjust the automatic transaxle range selector cable if necessary. Refer to Range Selector Lever Cable Adjustment .
- Install the throttle body air inlet duct. Refer to Air Cleaner Assembly Replacement in Engine Controls.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the automatic transaxle range selector cable bracket bolts to
25 N·m (18 lb ft).
