Important: Always maintain cleanliness when servicing fuel system components.

1. Relieve fuel system pressure. Refer to Fuel Pressure Relief .
2. Remove the fuel sender assembly. Refer to Fuel Sender Assembly Replacement .
3. Note strainer (3) position for future reference.



4. Support the reservoir with one hand and grasp the strainer with the other hand.
5. Use a screwdriver to pry the strainer ferrule off the reservoir.
6. Discard the strainer.

1. Install the new strainer (4) to the reservoir.
2. Support the reservoir with one hand and grasp the strainer with the other hand twisting the strainer into position.
3. Reinstall the fuel sender assembly. Refer to Fuel Sender Assembly Replacement .
4. Tighten the fuel fill cap.
5. Reconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in engine electrical.
6. Inspect for fuel leaks:

6.1.	Turn the ignition switch ON for 2 seconds.

6.2.	Turn the ignition switch OFF for `0 seconds.

6.3.	Turn the ignition switch ON.

6.4.	Check for fuel leaks.