Notice: Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.

1. Relieve coolant pressure.
2. Remove the air intake duct.
3. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in engine electrical.
4. Disconnect the ECT sensor electrical connector.
5. Using a deep well socket and extension, remove the sensor.

1. Coat engine coolant temperature sensor threads with sealer P/N 9985253 or equivalent.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the ECT sensor in engine.

Tighten
Tighten the sensor to 23 N·m (17 lb. ft.).

3. Connect the ECT sensor electrical connector.
4. Install the air intake duct.
5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in engine electrical.
6. Start engine.
7. Check for leaks.