Removal Procedure
- Open the hood.
- Remove the bolt that holds the front sheet metal diagonal brace to the inner fender.
- Remove the bolts that hold the front sheet metal diagonal brace to the radiator support.
- Remove the front sheet metal diagonal brace.
Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
• Air bag deployment • Personal injury • Unnecessary SIR system repairs • Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring. • If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System.
Installation Procedure
- Install the front sheet metal diagonal brace.
- Install the bolts to the front sheet metal diagonal brace at the radiator support.
- Connect the front sheet metal diagonal brace to the inner fender bolt and screw.
- Close the hood.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the sheet metal diagonal brace bolts to 47 N·m
(35 lb ft).
Tighten
Tighten the sheet metal diagonal brace bolts to 47 N·m
(35 lb ft).
