BULLETIN COVERS: (Figure 1)
Bench overhaul labor time for field service of the 1986 1/2 through 1988 HM-282 manual transaxle. Use the bench overhaul time listed below until vehicle divisions publish the next Labor Time Guide.
OPERATION DESCRIPTION OPERATION VEHICLE SERIES NUMBER A J N P W
TRANSAXLE ASSEMBLY K3100 - RECONDITION INC: R&R transaxle, replace clutch release bearing, adjust shift linkage. 4-CYLINDER TURBO -- 2.3 3.5 -- -- 4-CYLINDER QUAD 4 -- -- 3.5 -- -- 6-CYLINDER 2.3 3.5 -- 5.6 4.1
A) TO CHECK SHIM SELECTION ONLY* 2.6 2.6 2.6 2.6 2.6
C) TO REPLACE SIDE GEARS AND 1.4 1.4 1.4 1.4 1.4 PINIONS* D) TO REPLACE AXLE HOUSING 2.8 2.8 2.8 2.8 2.8 SIDE BEARINGS* E) TO REPLACE AXLE CASE HALF 1.2 1.2 1.2 1.2 1.2 (BELL HOUSING)* F) TO REPLACE SHIFTER FORKS 1.6 1.6 1.6 1.6 1.6 AND/OR INTERLOCK* G) TO REPLACE SHIFTER SHAFT* 1.1 1.1 1.1 1.1 1.1 H) TO RECONDITION INPUT SHAFT* 1.9 1.9 1.9 1.9 1.9 1) TO REPLACE SPEEDOMETER DRIVE 1.2 1.2 1.2 1.2 1.2 GEAR* J) TO RECONDITION OUTPUT SHAFT* 2.1 2.1 2.1 2.1 2.1 K) TO REPLACE TRANS CASE HALF* 2.3 2.3 2.3 2.3 2.3 L) TO RECONDITION TRANSAXLE 4.6 4.6 4.6 4.6 4.6 COMPLETE* NOTE: TOTAL ADD TIME NOT TO EXCEED THE "RECONDITION TRANSAXLE" ADD TIME.
General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.