Heater and Air Conditioning Control Replacement Pontiac

1. Remove the accessory trim panel. Refer to Instrument Panel Accessory Trim Plate Replacement in Instrument Panel, Gages and Console.



2. Remove the HVAC control assembly screws.



3. Disconnect the vacuum hose harness (1) from the HVAC control assembly.
4. Disconnect the rear defroster control electrical connector (2) from the HVAC control assembly.
5. Disconnect the vacuum hose harness connector (3) from the HVAC control assembly.
6. Disconnect the blower motor switch electrical connector (4) from the HVAC control assembly.

1. Connect the vacuum hose harness connector ( 1) to HVAC control assembly.
2. Connect the rear defroster control electrical connector ( 2) to the HVAC control assembly.
3. Connect the vacuum hose harness (2) hose connector (3) to the HVAC control assembly. Secure the connector on the tab.
4. Connect the blower motor switch electrical connector ( 4) to the HVAC control assembly.
5. Align the control assembly to the I/P.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.




6. Install the HVAC control assembly retaining screws.

Tighten
Tighten the screws to 2 N·m (18 lb in).

7. Install the accessory trim panel. Refer to Instrument Panel Accessory Trim Plate Replacement in Instrument Panel, Gages and Console.