Removal Procedure
- Use
a small flat-bladed tool on the retainer in order to release the power accessory receptacle
housing from the lower instrument panel (I/P).
- Remove
the power accessory receptacle housing from the lower I/P.
- Release
the electrical connector retainer tabs from the power accessory receptacle.
- Disconnect
the electrical connector from the power accessory receptacle.
- Remove the retainer and the housing from the bezel, if necessary.
Installation Procedure
- Install
the retainer and the housing to the bezel, if necessary.
- Connect the electrical connector to the power accessory receptacle.
- Position
the power accessory receptacle housing to the lower I/P.
- Install
the power accessory receptacle housing into the lower I/P. Press the housing into
place until fully seated.
- Inspect the power accessory receptacle for proper operation.