Headlamp Assembly or Headlamp Bulb and/or Cornering, Sidemarker, Park, Turn Signal Bulb Replacement Oldsmobile

Caution: Refer to Halogen Bulb Caution in the Preface section.

1. Open the hood.



2. Apply light pressure to the headlamp lens to hold the headlamp in place while releasing the retainers.
3. Lift up the headlamp retainers to release.
4. Remove the headlamp from the mounting panel.



5. Remove the sidemarker lamp bulb/socket from the headlamp by rotating counterclockwise.



6. Disconnect the electrical connector from the headlamp.



7. Remove the turn signal lamp bulb/socket from the headlamp by rotating counterclockwise.



8. Remove the rubber access covers from behind the headlamp bulbs to be replaced.



9. Remove the headlamp bulb/socket from the headlamp by rotating counterclockwise.



10. Disconnect the electrical connector from the headlamp bulb/socket.

1. Connect the electrical connector to the headlamp bulb/socket.



2. Install the headlamp bulb/socket to the headlamp rotating clockwise until fully seated.



3. Install the rubber access covers to the headlamp.



4. Install the turn signal lamp bulb/socket to the headlamp rotating clockwise until fully seated.



5. Connect the electrical connector to the headlamp.



6. Install the sidemarker lamp bulb/socket to the headlamp rotating clockwise until fully seated.



7. Position the headlamp mounting tabs to the slots in the upper fascia support and the fender reinforcement.
8. Apply light pressure to the headlamp lens to hold the headlamp in place while installing the retainers.
9. Align the headlamp retainers over the headlamp mounting tabs, then press the retainers down until fully seated.
10. Inspect the headlamp for proper fit.
11. Check and adjust the headlamp aim as necessary. Refer to Headlamp Aiming .
12. Close the hood.

Headlamp Assembly or Headlamp Bulb and/or Cornering, Sidemarker, Park, Turn Signal Bulb Replacement Pontiac

Caution: Refer to Halogen Bulb Caution in the Preface section.

1. Open the hood.
2. Remove the front air deflector. Refer to Front Air Deflector Replacement in Body Front End.
3. Apply light pressure to the headlamp lens to hold the headlamp in place while disconnecting the retainers.
4. Lift up the headlamp retainers to release.

Important: Note the location and position of the headlamp adjuster retainers and the locator tab.




5. Remove the headlamp, pulling straight forward from the headlamp mounting panel.



6. Disconnect the wiring harness from the headlamp.



7. Rotate the headlamp bulb/socket(s) counterclockwise to release.
8. Remove the headlamp bulb(s), if required.

1. Install the headlamp bulb(s), if required.
2. Rotate the headlamp bulb base clockwise to secure.



3. Connect the wiring harness to the headlamp.

Important: Note the location and position of the headlamp adjuster retainers and the locator tab.




4. Position the headlamp to the headlamp mounting panel.



5. Apply light pressure to the headlamp lens to hold the headlamp in place while installing the retainers.
6. Align the headlamp retainers over the headlamp mounting tabs, then press the retainers down until fully seated.
7. Inspect the headlamp for proper fit.
8. Install the front air deflector. Refer to Front Air Deflector Replacement in Body Front End.
9. Check the headlamp aim, If a new headlamp was installed, or if service or repairs in the front end area may have disturbed the headlamp mounting brackets. Refer to Headlamp Aiming .
10. Close the hood.