Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you perform the Lighting Systems Diagnostic System Check? | -- | Go to Step 2 | |
2 |
Does the test lamp light? | -- | Go to Step 3 | Go to Step 4 |
3 |
Does the test lamp light? | -- | Go to Step 5 | Go to Step 6 |
4 | Replace the right IP wiring harness junction block. Is the repair complete? | -- | System OK | -- |
5 | Connect a test lamp between terminal C and terminal A (Pontiac) or terminal B (Olds) of the left rear lamp assembly connector or between terminal C and terminal E (Pontiac) or terminal B (Olds) of the right rear lamp assembly connector. Does the test lamp light? | -- | Go to Step 7 | Go to Step 8 |
6 | Repair the open in the Back-up Lamp Feed circuit between the right IP wiring harness junction block and the left or right rear lamp assembly. Refer to Wiring Repairs in Wiring Systems. Is the repair complete? | -- | System OK | -- |
7 | Replace the inoperative rear lamp assembly. Refer to Tail Lamp Assembly and /or Backup, Sidemarker, Stop, Turn Signal Bulb Replacement or. Is the repair complete? | -- | System OK | -- |
8 | Repair the open in the Ground circuit between the rear lamp assembly and ground splice pack G401 (Olds.) and G 402 (Pontiac). Refer to Wiring Repairs in Wiring Systems. Is the repair complete? | -- | System OK | -- |
