REVISION: 04/11/97
THIS BULLETIN IS BEING REVISED TO UPDATE THE DRIVE AXLE NUT TIGHTENING SPECIFICATIONS FOR THE N CAR. PLEASE DISCARD CORPORATE BULLETIN NUMBER 73-32-03 (SECTION 3 - STEERING/SUSPENSION). ----------------------------------------------------------------------
THIS BULLETIN IS BEING ISSUED TO REVISE THE TIGHTENING SPECIFICATIONS IN SECTIONS 3B, 3C AND 4D OF THE SERVICE MANUAL AS FOLLOWS:
J CAR =====
SECTIONS 3B-8, 3B-9, 3C-5 AND 3C-13:
THE CORRECT TIGHTENING SPECIFICATION IS AS FOLLOWS:
- TIE ROD END TO KNUCKLE NUT 20 N.M (15 LB FT) PLUS 90 DEGREE ROTATION.
N CAR =====
SECTIONS 3C-6 AND 3C-16:
THE CORRECT TIGHTENING SPECIFICATION IS AS FOLLOWS:
- TIE ROD END TO KNUCKLE NUT 20 N.M (15 LB FT) PLUS 180 DEGREE ROTATION.
SECTION 3B-12:
THE CORRECT TIGHTENING SPECIFICATIONS ARE AS FOLLOWS:
- STEERING COLUMN LOWER PINCH BOLT 22 N.M (16 LB FT)
- STEERING COLUMN UPPER PINCH BOLT 22 N.M (16 LB FT)
SECTIONS 3C-16, 4D-4 AND 4D-5:
THE CORRECT TIGHTENING SPECIFICATION IS AS FOLLOWS:
- FRONT DRIVE AXLE NUT 385 N.M (284 LB FT) +/- 5 N.M (44 LB IN). REPLACE THE DRIVE AXLE NUT WITH A NEW ONE AFTER EVERY REMOVAL. NEVER RE-USE THE DRIVE AXLE NUT.
FIGURES: 00 ATTACHMENTS: 00
GENERAL MOTORS BULLETINS ARE INTENDED FOR USE BY PROFESSIONAL TECHNICIANS, NOT A "DO-IT-YOURSELFER". THEY ARE WRITTEN TO INFORM THOSE TECHNICIANS OF CONDITIONS THAT MAY OCCUR ON SOME VEHICLES, OR TO PROVIDE INFORMATION THAT COULD ASSIST IN THE PROPER SERVICE OF A VEHICLE. PROPERLY TRAINED TECHNICIANS HAVE THE EQUIPMENT, TOOLS, SAFETY INSTRUCTIONS AND KNOW-HOW TO DO A JOB PROPERLY AND SAFELY. IF A CONDITION IS DESCRIBED, DO NOT ASSUME THAT THE BULLETIN APPLIES TO YOUR VEHICLE, OR THAT YOUR VEHICLE WILL HAVE THAT CONDITION. SEE A GENERAL MOTORS DEALER SERVICING YOUR BRAND OF GENERAL MOTORS VEHICLE FOR INFORMATION ON WHETHER YOUR VEHICLE MAY BENEFIT FROM THE INFORMATION.
COPYRIGHT 1997 GENERAL MOTORS CORPORATION. ALL RIGHTS RESERVED.