GM Service Manual Online
For 1990-2009 cars only

Tools Required

J 25070 Heat Gun

Removal Procedure


    Object Number: 1300670  Size: SH
  1. Remove the front bumper fascia (2) from the vehicle. Refer to Front Bumper Fascia Replacement in Bumpers.
  2. Remove the two speed nuts (3) attaching the emblem (1) to the front bumper fascia (2).
  3. When replacing or repairing an emblem/nameplate do the following:
  4. 3.1. Use tape to protect the mounting surface during removal.
    3.2. Use tape for alignment marks for installation of the emblem/nameplate.

    Object Number: 643109  Size: SH
  5. To remove an emblem/nameplate, heat the emblem/nameplate using J 25070 .
  6. Hold the J 25070 approximately 152 mm (6 in) from the surface.

  7. Apply heat using a circular motion for about 30 seconds.

  8. Object Number: 321645  Size: SH

    Notice: Use a plastic, flat-bladed tool to prevent paint damage when removing an emblem/name plate.

  9. Use a plastic, flat-bladed tool to lift or remove the emblem/nameplate from the panel surface.
  10. Important: If tape is still intact on the molding or panel, do not remove the tape. Clean the tape and the mating surface with adhesive cleaner. Wipe the tape and the mating surface with a clean, lint free cloth. If the tape is damaged, continue with the replacement procedure.

  11. Apply the adhesive foam tape to the back of the emblem/nameplate and press the emblem/nameplate in place.
  12. When replacing, remove all adhesive as follows:
  13. • For body panels, use a 3M™ Scotch Brite molding adhesive remover disk 3M™ P/N 07501 or equivalent.
    • For plastic panels, use a lint free cloth and Varnish Makers and Painters (VMP) naphtha or a 50/50 mixture by volume of isopropyl alcohol and water to remove the adhesive.

Installation Procedure

    Important: Apply the emblem/nameplate in an environment that is free from dust or other dirt that could come into contact with the sticky backing. Foreign material may cause improper adhesion.

  1. Clean the area where the emblem/nameplate will be installed.
  2. Use a lint free cloth and Varnish Makers and Painters (VMP) naphtha or a 50/50 mixture by volume of isopropyl alcohol and water to clean the area.

  3. Dry the area thoroughly.

  4. Object Number: 1300670  Size: SH
  5. Use a J 25070 to heat the mounting surface to approximately 27-41°C (80-105°F), if necessary.
  6. Hold the J 25070 approximately 152 mm (6 in) from the surface.
  7. Ensure that the temperature of the emblem/nameplate is approximately 29-32°C (85-90°F).
  8. Remove the protective liner from the back of the emblem/nameplate.
  9. Position the emblem (1) to the location marks and press the emblem (1) to the mounting surface.
  10. Apply equal pressure along the emblem (1) to uniformly bond the item to the mounting surface.
  11. Remove the protective tape from the mounting surface.
  12. Install the two speed nuts (3) attaching the emblem (1) to the front bumper fascia (2).
  13. Install the front bumper fascia (2) to the vehicle. Refer to Front Bumper Fascia Replacement in Bumpers.